Avatar

Richard Balogh

Working with embedded systems since the 1987. At the beginning, the 8048 programmed in ASM, then 8051 in ASM, Basic and C, then Atmel AVR family (yes, before they became famous as an Arduino :), to nowadays ARM based micro:bit, RPi and others. Robotics competition pioneer.

  • Total activity 31
  • Last activity
  • Member since
  • Following 0 users
  • Followed by 0 users
  • Votes 3
  • Subscriptions 12

Activity overview

Latest activity by Richard Balogh
  • Richard Balogh commented,

    Thanks for a title, betatesting was a nice experience.  

  • Richard Balogh commented,

    For students, this is not a problem, as I can build the RC system with significantly larger time constant (1 sec). Of course, for real problems, where times are much shorter, there are other tools ...

  • Richard Balogh commented,

    Yes, exactly. I didn't set the controller parameters very well (intentionally), as I want to check whether it is possible to tune parameters using the control panel. I can demonstrate various optio...

  • Richard Balogh created a post,

    RC system voltage control

    Here is my experiment with simple 1st order control system (RC). Nice charts, possibility to control the experiment from the menu.

    • 2 followers
    • 4 comments
    • 0 votes
  • Richard Balogh created a post,
    Planned

    Chart start on signal

    It would be nice to have a possibility to start chart drawing on certain signal change (e.g. the HITI Data variable). Either binary only - on/off, either the analog value plus threshold.

    • 2 followers
    • 1 comment
    • 0 votes
  • Richard Balogh created a post,
    Completed

    RAM Tool address overleap

    Title: RAM tool address overleaps   Feature: RAM Tool Is this issue stopping you from further testing? No Arduino board: any Windows OS (type):  10 (64-bit) Steps to reproduce: Switching b...

    • 2 followers
    • 2 comments
    • 0 votes
  • Richard Balogh created a post,
    Completed

    Chart frozen

    At the certain moment (which I am not able to reproduce anymore) the Chart didnt enable to add new or delete old data. Everything worked, but I was unable to change the configuration. It was necess...

    • 2 followers
    • 2 comments
    • 0 votes
  • Richard Balogh created a post,
    Completed

    Output types

    I think it shouldn't be difficult to add two additional output types into the library. Instead of  HC_outputType(6, HIGH); // High = PWM, Low = Digital imagine that: HC_outputType(6, PWM); HC_outpu...

    • 2 followers
    • 1 comment
    • 0 votes
  • Richard Balogh created a post,
    Planned

    Analog outputs

    My opinion is, that for PWM and SERVO outputs they should be located in Analog I/O panel (as we are sending analog values out of the micro...) but it is not very important.   What I really am missi...

    • 2 followers
    • 1 comment
    • 0 votes
  • Richard Balogh commented,

    Preferably both possibilities for placing cursors, with config option in the menu. And measure window with all four measured possibilities.